ملحق تحريك موتور DC ثنائي L298N

غير متوفر ملحق تحريك موتور DC ثنائي L298N

General specifications

Motor driver: L298N
Motor channels: 2
Maximum operating voltage: 46 V
Peak output current per channel: 2 A
Minimum logic voltage: 4.5 V
Maximum logic voltage: 7 V
Package: Multiwatt15

 

Usage:

H-Bridge's are typically used in controlling motors speed and direction, but can be used for other projects such as driving the brightness of certain lighting projects such as high powered LED arrays.

How it works:

An H-Bridge is a circuit that can drive a current in either polarity and be controlled by *Pulse Width Modulation (PWM).

* Pulse Width Modulation is a means in controlling the duration of an electronic pulse. In motors try to imagine the brush as a water wheel and electrons as a the flowing droplets of water. The voltage would be the water flowing over the wheel at a constant rate, the more water flowing the higher the voltage. Motors are rated at certain voltages and can be damaged if the voltage is applied to heavily or if it is dropped quickly to slow the motor down. Thus PWM. Take the water wheel analogy and think of the water hitting it in pulses but at a constant flow. The longer the pulses the faster the wheel will turn, the shorter the pulses, the slower the water wheel will turn. Motors will last much longer and be more reliable if controlled through PWM.

Pins:

  • Out 1: Motor A lead out
  • Out 2: Motor A lead out
  • Out 3: Motor B lead out
  • Out 4: Mo (Can actually be from 5v-35v, just marked as 12v)
  • GND: Ground
  • 5v: 5v input (unnecessary if your power source is 7v-35v, if the power source is 7v-35v then it can act as a 5v out)
  • EnA: Enables PWM signal for Motor A (Please see the "Arduino Sketch Considerations" section)
  • In1: Enable Motor A
  • In2: Enable Motor A
  • In3: Enable Motor B
  • In4: Enable Motor B
  • EnB: Enables PWM signal for Motor B (Please see the "Arduino Sketch Considerations" section)

Specifications:

  • Double H bridge Drive Chip: L298N
  • Logical voltage: 5V Drive voltage: 5V-35V
  • Logical current: 0-36mA Drive current: 2A (MAX single bridge)
  • Max power: 25W
  • Dimensions: 43 x 43 x 26mm
  • Weight: 26g

*Built-in 5v power supply, when the driving voltage is 7v-35v

There are several different models of these L298N Dual H-Bridge Motor Controllers. The generic wiring schematic above should do the trick for most.

Two things to mention;

  • Make sure you have all of your grounds tied together; Arduino, Power source, and the Motor controller.
  • The PWM Pins are unnecessary if you do not want to control PWM features.

كتابة تعليق

الرجاء الدخول أو التسجيل لكي تتمكن من تقييم المنتج
  • Views: 942
  • الشركات RobotDyn
  • النوع : 1067
  • حالة التوفر : غير متوفر
37 Product(s) Sold
  • S.R 27